Skip Navigation Website Accessibility
logo

search our store

 
 


FAUX LEATHER SUBLIMATION KEY RING

1) Sticky lint roll both sides
2) Lay keychain down on a sheet of clean butcher paper
3) Lay the paper with the image face down on keychain. I use repositional spray to hold image on keychain- this is up to you whether you do this or tape- whatever meets your needs- you may have to experiment. You will want to wrap a piece of heat tape around the black fabric on the keychain.
4) Cover with another clean sheet of butcher paper
5) Press your design for 45-60 seconds at 385 degrees- light-medium pressure. Too much pressure will smoosh the keychain flatter.
6) Slowly raise your press and take paper and design off- doing too quickly can cause ghosting
7) Wait until it cools then repeat on other side- always use clean butcher paper when pressing so you don't transfer anything to your keychain


CONTACT US

    • D&K Computers & Crafts
      10 Pinsent Drive
      Grand Falls-Windsor,
      NL A2A 2R6
      709-489-2771